How do I allow Vendors to send me attachments through Vendor Discussions?

If you require Vendors to send you additional documentation, and you choose to do it through Bonfire's Messages section as an attachment, you'll need to enable attachments for a message thread in order to allow vendors to send you documentation. To do so, please follow the below instructions:

1. Click the Messages section, then click on Vendor Discussions.

2. Either locate the message thread where you would like to enable attachments or click on Start a new Vendor Discussion to begin a new thread. (If you are starting a new Vendor Discussion thread, you'll need to select a Recipient and add a subject line.)

3. Click on the toggle next to Vendor Attachments to enable it. The switch will turn blue when Vendor Attachments are accepted.

If this is a new thread, you'll need to complete the form and send a message to get the thread started. If it is an existing thread, you will be prompted to confirm whether or not you would like to enable attachments for the thread. 


Was this article helpful?

0 out of 0 found this helpful
Have more questions? Submit a request

Comments (0 comments)

Article is closed for comments.